Light Head Fidget Spinner #monsterschool #sirenhead #lighthead Follow me on Instagram – https://www.instagram.com/realplatabush/ Monster School : LIGHT HEAD Monster School : SIREN HEAD Music: ✔️https://incompetech.com ✔️Youtube Audio Library -There is no copyright infringement intended for the song or picture. If you have an issue with me posting this song orContinue Reading
This video is sponsored by Wargaming. World of Tanks is free to download https://tanks.ly/2GnXr6D Check out part 5 here https://youtu.be/-9c782blnEw Get your colinfurze merch here and support the channel https://www.colinfurzeshop.com See How I built it starting here with the Screws https://youtu.be/NASkgw9rufA Then the chassis and drivetrain https://youtu.be/1saFrMlRVc0 and the HydraulicsContinue Reading
I made this video to share one of my recent projects. This is a homemade, tracked, all-terrain vehicle, built almost entirely from scrap metal and junk that I was able to scrounge from parts boneyards and scrap piles. The entire project, from gathering junk to putting the final touches onContinue Reading
Robotics is very interesting subject but can be hard to start with. Because of that you can find a lot of robot kits on the market that you can learn robotics from. One of them is kuman robot kit, it has a camera that stream live image over WIFI andContinue Reading
How to make Arduino R/C Lawnmower Check the full tutorial here: http://goo.gl/olRf4S This project will show you how to make your Arduino into an R/C interface that you can use for just about anything requiring remote control. I will also show you how I built an R/C lawnmower using myContinue Reading
This was my very first boot, as seen on the video, code needed some review. As it get confuse when it approach an obstacle. , https://i.ytimg.com/vi/4KKbA1m54Y4/hqdefault.jpg sourceContinue Reading
This is a simple test of the robotic platform I intend to use. It’s currently under R/C control of my son, Kayden. Two Pronto Wheelchair Motors, Sabertooth 2×25 Motor Controller wired in with an Arduino and Spectrum R/C receiver, Two 12v Gel Batteries, Steel welded frame. Note that the DremalContinue Reading
, https://i.ytimg.com/vi/RgNwtTs3CAE/hqdefault.jpg sourceContinue Reading
I designed the tank in a way that it can be almost completely 3D-printed. It’s of course inevitable to truely completely 3D print the tank so there are small additional parts needed like bearings, shafts, screws, bolts and nuts. The tracks however are completely 3D-printed and don’t need little shaftsContinue Reading