Let’s see if the 4-stroke bike can handle nitrous oxide (NOS). We’ll also test nitrous in the engine with the see-through cylinder head. In this video, you’ll see pre-ignition take place inside the see-through engine. Thanks to everyone who requested this video. I greatly appreciate your ideas for future videos.
Nitrous kit: https://amzn.to/2QiJ74m
Videography Equipment:
Sony DSC-RX10 III Cyber-shot Digital Still Camera: https://amzn.to/2YdXvPw
Canon 70D Camera: https://amzn.to/31b5Gy0
Azden Microphone: https://amzn.to/34d3DLE
Go Pro Bundle: https://amzn.to/31aince
➡ Thank you very much for supporting the channel: https://www.patreon.com/projectfarm
➡ An easy way to find past videos along with products tested: http://bit.ly/2FCrBpk A big thanks to Jim for putting this together.
➡ Merch: www.Project-Farm.com
➡ Click here if you’d like to subscribe: https://www.youtube.com/channel/UC2rzsm1Qi6N1X-wuOg_p0Ng?sub_confirmation=1
➡ As an Amazon Associate I earn from qualifying purchases.
This video is only for entertainment purposes. If you rely on the information portrayed in this video, you assume the responsibility for the results. Project Farm LLC
, https://i.ytimg.com/vi/Wmg0bzuO1Mc/hqdefault.jpg
source
I had a LOT of fun with this video and thanks to everyone who suggested this video idea! Here's the kit I used but it is very expensive. Recommend shopping around for a better price. Nitrous kit: https://amzn.to/2QiJ74m
Will this work on my e-bike?
40 MPH on a bicycle is pretty sketchy.
I have a couple push mowers I can donate to science.
Very detailed and interesting video!
I'd use it for racing or an extra boost but sparingly
You would get better performance if you could rig up a way to increase the fuel mixture when it gets the shot of NOS. That would not only add more power, but would cool the charge a tiny bit. Maybe even move the magneto somehow to retard the timing by 5 or 10 degrees.
Vin Diesel yelling "NOS!" Followed by blue flame explosions.
She cany take it captain?The warp drives gona blow.
I’ve had 3 modular Ford engines that ping under high load around 4200 RPM it’s interesting to see what it looks like when it’s happening. If you own a Ford engine and hear the same ping in talking about , use Lucas upper cylinder lube.
Great video! Thanks for all of it!
One of the CC messages @ the bicycle section says it was knocking, needed a colder plug. I'm assuming you did that, but want to verify. Also, since then have you tried to tweak it anymore and found and other results with the bicycle?
A bit old video, so I do recommend to do a similar one using NOS on 2-stroke engine! Hope to see it soon! Have a great weekend!
Nitrous must be leaking with the big ol smile 😉
What is nitrous oxide made out of
I giggled like an idiot when I read the title. Love this guy. Can we be friends
Careful…might blow the welds off the intake…
You need to add extra fuel with the nitrous or it doesn't work properly, you'll be running lean. This is how people break engines.
Do you think it would be ok to use on a 50cc moped engine? Asking for a friend
Whats holding up the flap on the lawnmower?
Youll need xtra fuel when hitting the nitrous.. A dry nitrous charge will make it run way lean hence the engine knock/pinging..
You could allways have the motor run very rich before hitting the button, for a better A/F ratio while nos is active.. Though i think the valves/rod will snap due to over reving..
Try methanol and stiffer valve Springs
If your going to drill in a place you don't want shavings put some grease on the bit..Most of the shavings will it here to the bit. As always thank you
You need the tail wind ? nice job
you do excellent video's , you are the BEST at what you do………………..
Try pure oxygen instead of nitrous, whom else in the crowd would like to see project Farm do that?
This guy has the same expression as Sheldon had for Flag Review Episodes
This project was childish and just a bad idea… I loved it!!!!! Educational and fun!
I know this is an old video, don't you need some way to add extra fuel for the oxygen in the nitrous to combine with, just adding nitrous will make the engine run way lean.
I would love to see an e-bike conversion test and review from cheap kits to the more expensive ones.
Thank you
It would be cool to see a compressed air boost shot tested also
Pro tip : dad always puts a zip tie on the plug wire to pull it off with?
Sir can I get engine.. please sponsor me. It's my dream to fix an engine in an cycle… Sir can you please make it true…. Please sir
Turbocharge it next!
Bro it's called "naws" Paul Walker is rolling in his grave. Jeez
Love the install? I wonder what it would do with some actual enrichment
Nice video!
I would expect to add also more fuel in order to balance the nitrous, it appears that the engine was tuned rich!
I want to see you pedal a bicycle and see how fast you can go. Then, hook the nitrous to a nose cannula and breathe nitrous and see if you can pedal any faster.
Your the Coolest Mad Scientist on YouTube lol ??? no one does the things you do.
Hello project farm I am in the process of putting a lawnmower engine on my pocket bike I converted it to a horizontal shaft engine and I will use a belt clutch it’s 6 hp can you put one on a bicycle to see the power and top speed?
First time you’ll get dragged by your self propelled mower! ?
I would love to see you use a Volkswagen smog pump as a supercharger, THEN hook up that nitrous kit. ?
uhhhhhh… I dont think this kit was made for engines… I think Steve-O would agree…
Over 40 on a bicycle must be quite a rush.
Get Cleetus McFarland on the phone, he has 20Lb bottles on standby!
Looks more like a do it yourself rave in a box.
Wtf, they just ship whippits to your door??
I was in a hit-and-run car accident 2 yrs ago so to give me a chance to type. I'm now just learning how to talk… sorry.. The Florida pool pump motor repair guy approved ! that was good info Farm man
You should put a turbo on one
Hey can you try nitrous oxide on a 2stroke engine ?