3 Comments

  1. How did you setup the open cv with raspberry pi? Did you use python for it, and how did you get started. I’m working on a similar project and I have the arduino part down, but the raspberry pi and open cv part is where I get stuck. If you can share any tutorial you might have used that would be super helpful. Working on a mac btw

  2. Hi ? it’s me again. Do you mind explaining the communication between the RaspberryPi and Arduino. Like how to send simplified motor control commands through Python or the code if you don’t mind ? I’m not too familiar with arduinos but they seem similar to mbed boards from what I see ??

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.